Lenovo 7269D7U - Topseller M58e Sff E7500 2.93G 3Gb 320Gb Dvdrw W7p/Xpp Hardware Maintenance Manual page 60

Diagnostic Error Code
025-027-XXX IDE interface Configuration/Setup error
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface
failure
025-195-XXX IDE interface Test aborted by user
025-196-XXX IDE interface test halt, error threshold
exceeded
025-197-XXX IDE interface test warning
025-198-XXX IDE interface test aborted
025-199-XXX IDE interface test failed, cause unknown
030-000-XXX SCSI interface Test Passed
030-00X-XXX 030-01X-XXX SCSI interface failure
030-027-XXX SCSI interface Configuration/Setup error
54
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. IDE signal cable
2. Flash the system. See "Flash update procedures"
on page 521
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Check power supply
3. Reseat IDE signal cable
4. IDE device
5. System board
Information only Restart the test, if necessary
1. Press F3 to review the log file
2. Restart the test to reset the log file
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 39
2. Flash the system and re-test. See "Flash update
procedures" on page 521
3. Go to "Undetermined problems" on page 65
1. Go to "Undetermined problems" on page 65
2. Flash the system and re-test. See "Flash update
procedures" on page 521
3. Replace component under function test
No action
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Flash the system. See "Flash update procedures"
on page 521
3. SCSI device
4. SCSI adapter card, if installed
5. System board