IBM 2158240 - Aptiva E - 2158 Maintenance And Service Manual page 80

•
End.
003 -
•
Select Utility from the menu.
•
Select and execute Tech Support Form from the menu to generate a system
configuration report.
•
Compare the system configuration list with the actual devices installed in
system.
NOTE: If necessary, remove the cover and visually compare the devices
installed in the system unit to those shown in the Tech Support Form.
004 - IF THE NUMBER OF DISKETTE, HARD DISK, OR CD-ROM DRIVE IS
NOT CORRECT, READ AHEAD; OR GO TO STEP 005.
•
Check the cable installation of all disk drives.(See "Machine Type 2158
System Board Jumpers and Connectors" on page 107 and"Machine Type
2163 System Board Jumpers and Connectors" on page 111.)
- Diskette drive should be connected to the system board connector CN11
for 2158 and CN5 for 2168.
- IDE Primary Channel Master and Slave Drives in BIOS Setup should be
connected to the system board connector CN9 for 2158 and CN11 for
2168.
- IDE Secondary Channel Master and Slave Drives in BIOS Setup should be
connected to the system board connector CN10 for 2158 and CN10 for
2168.
NOTE: The CD-ROM drive that comes with system unit should be configured
as IDE Secondary Channel Master device.
•
Check all power supply voltages, switch, and jumper settings before you
replace the system board. (See "Machine Type 2158 System Board
Jumpers and Connectors" on page 107 and"Machine Type 2163 System
Board Jumpers and Connectors" on page 111.)
•
Check the power supply voltages if you have a "system no-power" condition.
See "Power Supply Connectors and Voltages" on page 114.
•
Check the hard disk and CD-ROM drives jumper settings. See "3.5-In. Hard
Disk Drive Jumper Settings" on page 117 and "5.25-In. Hard Disk Drive
Jumper Settings" on page 120.
•
Check the voltages of all disk drive power connectors. See "Power Supply
Connectors and Voltages" on page 114.
•
Correct the parameter settings under Disk Drives in the BIOS Setup. See
"Hard Disk Drive" on page 3.
48