Solving Problems; Self-Test Feature Check (Stfc) - Dell 1704FPV - UltraSharp - 17" LCD Monitor User Manual

Back to Contents Page

Solving Problems

Dell™ 1704FPV Flat Panel Monitor
Troubleshooting Your Monitor
General Problems
Product Specific Problems
USB Problems
Troubleshooting Your Soundbar
CAUTION: Before you begin any of the procedures in this section, follow the
Troubleshooting Your Monitor

Self-Test Feature Check (STFC)

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your
monitor and computer are properly connected but the monitor screen remains dark, run the monitor self-test by performing
the following steps:
1. Turn off both your computer and the monitor.
2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital
(white connector) and the Analog(blue connector) cables from the back of computer.
3. Turn on the monitor.
The floating 'Dell - Self-Test Feature Check' dialog box should appear on-screen (against a black
background) if the monitor cannot sense a video signal and is working correctly. While in self-test mode,
the power LED remains green. Also, depending upon the selected input, one of the dialogs shown below
will continuously scroll through the screen.
This box also appears during normal system operation if the video cable becomes disconnected or
damaged.
4. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video controller and computer system;
your monitor is functioning properly.
or
safety instructions.