Solving Problems; Common Problems - Dell 2009W User Manual

Back to Contents Page

Solving Problems

Dell™ 2009W Flat Panel Monitor User's Guide
Troubleshooting Your Monitor
Common Problems
Product Specific Problems
Universal Serial Bus Specific Problems
Dell™ Soundbar Troubleshooting
CAUTION: Before you begin any of the procedures in this section, follow the
Troubleshooting Your Monitor
Self-Test Feature Check
Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly
connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:
1. Turn off both your computer and the monitor.
2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both the Digital (white connector) and the Analog
(blue connector) cables from the back of computer.
3. Turn on the monitor.
The floating dialog box should appear on-screen (against a black background), if the monitor cannot sense a video signal and is working correctly.
While in self-test mode, the power LED remains green. Also, depending upon the selected input, one of the dialogs shown below will continuously
scroll through the screen.
4. This box also appears during normal system operation if the video cable becomes disconnected or damaged.
5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning
properly.

Common Problems

The following table contains general information about common monitor problems you might encounter and the possible solutions.
Common Symptoms
No Video/ Power LED off No picture
No Video/ Power LED on No picture or no
Poor Focus
Shaky/Jittery Video
Downloaded from ManualMonitor.com Manuals
What You
Experience
Ensure that the video cable connecting the monitor and the computer is properly connected and secure.
l
Verify that the power outlet is functioning properly by using any other electrical equipment.
l
Ensure that the power button is depressed fully.
l
Increase brightness & contrast controls via OSD.
l
brightness Perform monitor self-test feature check.
l
Check for bent or broken pins in the video cable connector.
l
Picture is fuzzy, Perform Auto Adjust via OSD.
l
blurry, or ghosting Adjust the Phase and Pixel Clock controls via OSD.
l
Eliminate video extension cables.
l
Reset the monitor to Factory Settings.
l
Change the video resolution to the correct aspect ration (16:10).
l
Wavy picture or Perform Auto Adjust via OSD.
l
fine movement Adjust the Phase and Pixel Clock controls via OSD.
l
Reset the monitor to Factory Settings.
l
Check environmental factors.
l
Relocate the monitor and test in another room.
l
Safety Instructions.
or
or
Possible Solutions