New And Changed Information - Cisco 7206 - VXR Router Configuration Manual

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m

New and Changed Information

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus
7000 Series NX-OS Interfaces Configuration Guide, Release 5.x. The latest version of this document is
available at the following Cisco website:
http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_
cli.html
To check for additional information about Cisco NX--OS Release 5.x, see the Cisco Nexus 7000 Series
NX-OS Release Notes, Release 5.x. Release notes are available at the following Cisco website:
http://www.cisco.com/en/US/products/ps9402/prod_release_notes_list.html
Table 1
Configuration Guide, Release 5.x, and tells you where they are documented.
Table 1 New and Changed Features for Cisco NX--OS Release 5.x
Feature
Fabric Extender (FEX)
BFD SHA1
Authentication
Default Interfaces
SVI Autostate Exclude
vPC
Rate Limits
OL-23435-03
summarizes the new and changed features for the Cisco Nexus 7000 Series NX-OS Interfaces
Description
Fabric Extender ports have Layer 3 support for
host connectivity, and vPCs can be configured
through Fabric Extenders (Host vPC).
Supports SHA-1 authentication of BFD
packets.
Allows you to clear the existing configuration
of multiple interface types.
Allows you to exclude a port from the VLAN
interface link-up calculation when there are
multiple ports in the VLAN.
Allows you to configure auto recovery
configuration support, provides system display
of MST to VLAN consistency failures,
provides FabricPath configuration support,
and vPC connection to Cisco 2000 Series
Fabric Extenders.
Configures rate limits for packets that reach
the supervisor.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
Changed in
Release Where Documented
5.2(1) Chapter 4, "Configuring Layer 3
Interfaces"
Chapter 7, "Configuring vPCs"
5.2(1) Chapter 5, "Configuring
Bidirectional Forwarding
Detection"
5.2(1) Chapter 3, "Configuring Layer 2
Interfaces"
5.2(1) Chapter 3, "Configuring Layer 2
Interfaces"
5.2(1) Chapter 7, "Configuring vPCs"
5.1(1) Chapter 2, "Configuring Basic
Interface Parameters"
xiii