Manual Sewing (Manual Mode) - Brother RH-9820 Instruction Manual

7. USING THE SEWING MACHINE (OPERATION PANEL: ADVENCED OPERATION)

7-6. Manual sewing (manual mode)

The hammer may operate during manual mode, so do not put your hands near the hammer at this time.
If care is not taken, injury may result.
You can turn the upper shaft pulley by hand to move the feed base one stitch at a time. This is useful to do when adjusting the
spreader timing. (Refer to "9-10. Adjusting the spreader timing".)
1
Switch the mode to manual mode.
0433B
2
Select the desired program number (2).
0413B
3
Place the material to be sewn under the work clamps, and then press the work clamp switch (6).
(6)
0531B
4
Press the start switch (7).
0532B
65
CAUTION
The program number (2) changes in the order shown in the illustration
each time the
opposite direction.)
(7)
RH-9820
(3)
(1)
(5)
The sewing shape (1), program number (2), cutting
operation (3), total number of stitches (4) and number of
stitches remaining (5) will appear in the display.
Independent program
(Refer to P. 39)
key is pressed. (The
The work clamps will be lowered.
The feed base will move to the sewing start position.
NOTE:
If cutting operation is set to "Cutting before sewing", the
hammer will operate.
(2)
(4)
Cycle program
(Refer to P. 57)
(2)
key changes the order in the
0225B
0337B
0225B