Setting The Material - Brother RH-9820 Instruction Manual

4. PREPARATION BEFORE SEWING

4-6. Setting the material

Cloth guides (2) are attached to the left and right work clamp plates (1). The material can be set so that it is vertical and parallel
to the sewing machine by aligning the edges of the material with the cloth guides (2). In addition, the width (sewing margin)
between the edge (top edge) of the material and the sewing pattern can be adjusted by changing the installation positions of
the cloth guides (2).
35
Setting the material
Set the material so that its edges are aligned with the cloth
guides (2) as shown in the illustration.
0478B
Adjusting the sewing margin
0479B
<For -00 and -01 specifications>
1. Loosen the screws (3) at the left and right, and then move
the cloth guides (2) forward or back to adjust the sewing
margin <a>.
* <a> can be adjusted to between 10 - 30 mm.
2. Once adjustment is complete, securely tighten the
screws (3).
<For -02 specifications>
There are two installation holes (4) for the left and right
screws (3), one at the front and one at the back.
1. Move the screws (3) to whichever installation hole (4) is
needed.
2. With the screws (3) loosened, move the cloth guides (2)
forward or back to adjust the sewing margin <a>.
* Adjustment range for <a>
The following adjustment ranges can be obtained by
changing the installation holes (4).
Sewing length
L1422
L1826
L2230
L2634
L3442
3. Once adjustment is complete, securely tighten the
screws (3).
0480B
RH-9820
Adjustment range
10 - 50 mm
10 - 46 mm
10 - 42 mm
10 - 38 mm
10 - 30 mm