Changing The Cycle Program Counter; Setting The Number Of Home Position Cycles - Brother RH-9800 Instruction Manual

7. SEWING

7-11. Changing the cycle program counter

The cycle program counter can be easily changed if necessary, for instance because re-sewing was necessary.
(J)
(K)
(M)

7-12. Setting the number of home position cycles

The number of home position cycles can be set in order to shorten the overall cycle time.
* This function is only valid when DIP switch No. 8 on the circuit board is set to ON.
(1)
40
1. If carrying out cycle sewing in AUTO mode, switch the
1185Q
contents shown in the front panel display from the
production counter to the cycle program.
The program number which is to be sewn next will
flash in the display. To change the cycle program
counter (the position where the display is flashing),
press the "up" button (L) or the "down" button (K) to
make the desired setting.
* If you would like to switch the display from the cycle
(L)
program to the production counter, press the
SELECT button (M). The production counter will be
displayed while this switch is being pressed.
1186Q
1. Press the MODE button (1) to switch to program
1187Q
mode.
2. Press the SELECT button (M) so that "HP" is
displayed in the front panel display.
* The display will change in the following order each
time the SELECT button is pressed:
A
(Continued on next page)
1188Q
RH-9800
B P4 HP