Installation; Connect Your Dap-1320 To Your Router; Connect Dap-1320 To Router - D-Link DAP-1320 User Manual

Section 2 - Installation

Connect your DAP-1320 to your Router

The easiest and most secure way to connect your DAP-1320 to your the router or access point is WPS (Wi-Fi Protected Setup).
Please refer to your user manual for information on your router or access point make sure you understand how to enable WPS.
Once you know, follow the steps below:
Step 1 - Plug the DAP-1320 into a wall outlet and verify if the power
LED has turned from red to a blinking amber.
Step 2 - Press the WPS button on your AP/Router.
Note: Usually the WPS LED will blink once it is pressed. Check your
router's manual for more information.
Step 3 - Press and hold the WPS button until the light starts blinking
green and then release. Please allow up to two minutes for
the WPS process to finish. Once the connection is successful
the LED will be solid green.
D-Link DAP-1320 User Manual

Installation

DAP-1320
WPS Button
WPS Button
7