Section 3 - Configuration
It is recommended to enable wireless security on your DAP-1320 before your wireless clients. Please establish wireless
connectivity before enabling. Your wireless signal may degrade when enabling encryption due to the added overhead.
1. Log into the web-based configuration by opening a web browser
and entering http://dlinkap.local. Click Setup and then click
Wireless Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to Pre-Shared Key, enter a key (Wi-Fi password). The Wi-Fi
password must be between 8-63 characters and is case-sensitive.
4. Click Save Settings at the top of the window to save your
settings. You will lose connectivity until you enable WPA-PSK
on the device you are working from and enter the same Wi-Fi
password as you did on the DAP-1320.
D-Link DAP-1320 User Manual
Configure WPA/WPA2 Personal
23