What To Do If - Electrolux EHD 72100-X Installation And Operating Instructions Manual

What to do if ...

Problem
The cooking zones will not
switch on or are not function-
ing
The residual heat indicator is
not displaying anything
Power function cannot be
switched on
Display changes between
two heat settings
lights up
is lit
22
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Safety cut-out has been trig-
gered
The cooking zone was only
on for a short time and is
therefore not hot
The Power function function
has already been activated
several times quickly one af-
ter the other
Power Management is reduc-
ing the power of this cooking
zone
Unsuitable cookware
No cookware on the cooking
zone
The diameter of the bottom
of the cookware is too small
for the cooking zone
Overheating protection for
the cooking zone has been
triggered
Safety cut-out has been trig-
gered
Remedy
Switch the appliance on
again.
Deactivate the child safety
device (See the section
"Child safety device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
Let cooking surface cool
down.
See section "Power Manage-
ment" in the Operating the
Appliance chapter
Use suitable cookware
Place cookware on the cook-
ing zone
Move onto a smaller cooking
zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again