2U rack bezel option
The 2U rack bezel helps prevent any unauthorized physical access to the server in the rack configuration. To
access the hard drive cage, you must unlock and open the 2U rack bezel.
To unlock the 2U rack bezel, use the key provided with the kit.
Install the 2U rack bezel into the chassis, and then lock the 2U rack bezel with the key.
HP Trusted Platform Module option
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
Installing the Trusted Platform Module board.
1.
Retaining the recovery key/password (on page 89).
2.
Enabling the Trusted Platform Module (on page 89).
3.
Enabling the TPM requires accessing RBSU
information about RBSU, see the HP website (http://www.hp.com/go/ilomgmtengine/docs).
TPM installation requires the use of drive encryption technology, such as the Microsoft Windows BitLocker
Drive Encryption feature. For more information on BitLocker, see the Microsoft website
(http://www.microsoft.com).
CAUTION:
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines:
•
Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
•
When installing or replacing hardware, HP service providers cannot enable the TPM or the encryption
technology. For security reasons, only the customer can enable these features.
Always observe the guidelines in this document. Failure to follow these guidelines
("HP ROM-Based Setup
Utility" on page 103). For more
Hardware options installation 86