Removing An Internal 3.5-Inch Hard Drive - HP Elite 7000 - Microtower PC Maintenance And Service Manual

Removing an Internal 3.5-inch Hard Drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive,
make sure you have created a Recovery Disc Set to restore the operating system, software drivers, and
any software applications that were preinstalled on the computer. If you do not have this CD set,
select Start > HP Backup and Recovery and create it now.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the two screws that secure the hard drive cage to the chassis.
Figure 7-24
4. Push down the latch on the side of the hard drive cage (1), then slide the hard drive cage away
from the bottom of the chassis (2) as shown below.
Figure 7-25
(Access Panel on page
Removing the Hard Drive Cage Screws
Releasing the Hard Drive Cage
(Preparation for Disassembly on page
30).
29).
Drives 51