Toshiba PQX32U-04M01M User Manual page 179

Problem
External monitor
Please also refer to Chapter 8,
supplied with your monitor for further information.
Problem
Monitor does not turn
on
No display
Display error occurs
User's Manual
Procedure
Check within the Windows Device Manager
application to ensure the sound function is
enabled.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
Optional Devices, and to the documentation
Procedure
After confirming that the monitor's power switch
is on, you should check the connections to make
sure that the power cord/adaptor is firmly
connected to the monitor and to a working power
outlet.
Try adjusting the contrast and brightness
controls on the external monitor.
Press the Fn + F5 hot key in order to change the
display priority and ensure that it is not set for the
internal display panel only.
Check to see if the external monitor is
connected.
When the external monitor is set as the primary
display device in extended desktop mode, it will
not display when the computer wakes up from
Sleep Mode if the external monitor has been
disconnected while in Sleep Mode.
To keep this from happening, do not disconnect
the external monitor while the computer is in
Sleep or Hibernation Mode.
Remember to turn off the computer before
disconnecting the external monitor.
When the display panel and an external monitor
are set to clone mode and the monitors are
turned off by the timer, the display panel or the
external monitor may not display when turned on
again.
If this occurs, press Fn + F5 to re-set the display
panel and external monitor to clone mode.
Check that the cable connecting the external
monitor to the computer is firmly attached.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
Troubleshooting
9-20