Pc Card Assembly - Compaq M300 - Armada - PII 333 MHz Maintenance And Service Manual

5.18 PC Card Assembly

IMPORTANT: There are different-sized screws securing the PC Card assembly to the
system board. Make note of the location of these screws.
Prepare the computer for disassembly (Section 5.5).
1.
Remove the modem or modem/NIC card (Section 5.9).
2.
Remove the keyboard (Section 5.11).
3.
Remove the switch cover (Section 5.13).
4.
Remove the display assembly (Section 5.14).
5.
Remove the top cover (Section 5.15).
6.
Remove the modem connector board (Section 5.17).
7.
Remove the two silver screws
8.
.
26)
Remove the black screw
9.
assembly.
Lift the left side of the PC Card assembly
10.
Figure 5-26. Removing the PC Card Assembly
Reverse the above procedures when installing the PC Card assembly.
IMPORTANT: Be sure to route the audio and light board cables between the PC Card
assembly and the base plastic. Do not route the cables near the heat sink.
5-28 Removal and Replacement Procedures
on the left side of the PC Card assembly (Figure 5-
securing the front of the PC Card assembly to the base
to disconnect it from the system board.