Troubleshooting; Preliminary Steps; Power-On Self-Test (Post) - Compaq M300 - Armada - PII 333 MHz Maintenance And Service Manual

2
chapter
Follow these basic steps when beginning the troubleshooting process:
1. Complete the preliminary steps listed in Section 2.1.
2. Run the Power-On Self-Test (POST) as described in Section 2.3.
3. Run Computer Setup as described in Section 2.5.
4. If you are unable to run POST or if the problem persists after running POST,
perform the recommended actions described in the diagnostic tables in Section 2.5.
Follow these guidelines when troubleshooting:
Complete the recommended actions in the order in which they are given.
I
Repeat POST after each recommended action until the problem is resolved and the
I
error message does not return.
When the problem is resolved, stop performing the troubleshooting steps and do not
I
complete the remaining recommended actions.
Refer to Chapter 5 for recommended removal and replacement procedures.
I
If the problem is intermittent, check the computer several times to verify that the
I
problem is solved.
The following table describes the troubleshooting actions:
I
I
I
I

Troubleshooting