Compaq N800v - Evo Notebook - Pentium 4-M 1.7 GHz Hardware Manual page 35

Pointing Devices and Keyboard
The
Fn+F2
Computer Setup. The device in the MultiPort can be set to remain
on or off while the
Fn+F2
Setup is a non-Windows utility. For more information about using
Computer Setup, refer on this CD to the Software Guide, "Setup
and Diagnostic Utilities" section.
1. To open Computer Setup, turn on or restart the notebook,
then press
displayed in the lower left of the screen.
❏
❏
2. Use the arrow keys to select the Security menu, then press
enter.
3. Use the arrow keys to select Device Security, then press
4. Select MultiPort Fn+F2. The status of the device in the
MultiPort is displayed at the bottom of the screen.
5. To change the status of the device in the MultiPort, press the
Fn+F2
whichever status is selected at the time that the
are disabled.)
6. To disable the
MultiPort Fn+F2 to Disable. (To reenable the
set this status field to Enable.)
7. To confirm your settings, press
8. To exit Computer Setup, use the arrow keys to select an exit
option from the File menu, then follow the instructions on
the screen.
Your preference is set as you exit Computer Setup and is in effect
when the notebook restarts.
2–8
hotkeys are enabled by default, but can be disabled in
Fn+F2
hotkeys preferences are set in Computer Setup. Computer
while the F10 = ROM Based Setup message is
F10
To change the language, press
To view navigation information, press
hotkeys. (The device in the MultiPort will remain in
Fn+F2
hotkeys are disabled.
F2.
hotkeys, set the status field beside
F10.
F1.
enter.
hotkeys
Fn+F2
hotkeys,
Fn+F2
Hardware Guide