Remove the management port option cover.
4.
Using a T-15 Torx screwdriver, install the dedicated LO100c management port module.
5.
Install the primary access panel.
6.
Install the server into the rack.
7.
Connect the dedicated LO100c management port to a LAN from which the server is managed.
8.
Connect the AC power cord to the AC power source.
9.
Wait 3 minutes for LO100c firmware initialization to complete.
10.
The dedicated LO100c management port supports DHCP-assigned and static IP addresses. To configure
network access, see the HP ProLiant Lights-Out 100 Remote Management User Guide on the HP website
(http://www.hp.com/servers/lights-out).
Hardware options installation 30