Intel D845GLLY Specification page 20

Specification Update for Intel
Table 18 describes the two configurations of this connector/jumper block.
CAUTION
Do not place jumpers on this block in any configuration other than the one
described in Table 18. Other jumper configurations are not supported and could
damage the Desktop Board.
Table 18. Front Panel Audio Connector/Jumper Block
Jumper Setting
1 2
3 4
5 6
5 and 6
7
9 10
9 and 10
1
2
No jumpers
3 4
installed
5 6
7
9 10
#
INTEGRATOR'S NOTE
When the jumpers are removed and this connector is used for front panel audio,
the back panel audio line out and mic in connectors are disabled.
2.3.2 BIOS SETUP CONFIGURATION JUMPER BLOCK
The 3-pin jumper block determines the BIOS Setup program's mode. Table 18A describes the jumper
settings for the three modes: normal, configure, and recovery. When the jumper is set to configuration mode
and the computer is powered-up, the BIOS compares the processor version and the microcode version in the
BIOS and reports if the two match.
14

Desktop Boards Using the Intel
Configuration
Audio line out signals are routed to the back panel
audio line out connector.
Audio line out and mic in signals are available for front
panel audio connectors.

845GL Chipset