Intel D845GLLY Specification page 15

Specification Update for Intel
Figure 1
(continued)
A Audio codec
B Auxiliary line-in connector
C ATAPI CD-ROM connector
D Back panel connectors
E +12V power connector (ATX12V)
F Rear chassis fan connector

G Intel 82845GV Graphics and Memory
Controller Hub (GMCH)
H mPGA478 processor socket
I Processor fan connector
J DIMM sockets
K Serial port B connector
L I/O Controller
M Power connector
N Diskette drive connector
Figure 1. Desktop Board D845GLAD Components
5. Change to Description of Section 2.2, Connectors
Section 2.2, Connectors will change in its entirety as follows:
2.2 Connectors
CAUTION
Only the back panel USB, front panel USB, VGA, and PS/2 connectors have
overcurrent protection. The Desktop Boards' internal connectors are not
overcurrent protected and should connect only to devices inside the computer's
chassis, such as fans and internal peripherals. Do not use these connectors to
power devices external to the computer's chassis. A fault in the load presented
by the external devices could cause damage to the computer, the interconnecting
cable, and the external devices themselves.

Desktop Boards Using the Intel
O IDE connectors
P Speaker
Q Battery
R Auxiliary front panel power LED
connector
S Front chassis fan connector
T Chassis intrusion connector
U BIOS Setup configuration jumper
block
V 4 Mbit Firmware Hub (FWH)
W Front panel connector
X Front panel USB connector

Y Intel 82801DB I/O Controller Hub
(ICH4)
Z PCI bus add-in card connectors
AA Front panel audio connector

845GL Chipset
9