Jumper Block; Location Of The Jumper Block; Bios Setup Configuration Jumper Settings - Intel D845GLLY Specification

2.3 Jumper Block

CAUTION
Do not move the jumper with the power on. Always turn off the power and unplug the power cord
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
Figure 6 shows the location of the jumper block.
3
J9H2
The 3-pin jumper block determines the BIOS Setup program's mode. Table 18 describes the
jumper settings for the three modes: normal, configure, and recovery. When the jumper is set to
configuration mode and the computer is powered-up, the BIOS compares the processor version and
the microcode version in the BIOS and reports if the two match.
Table 18.

BIOS Setup Configuration Jumper Settings

Function/Mode
Normal
Configure
Recovery
1
Figure 6. Location of the Jumper Block
Jumper Setting Configuration
The BIOS uses current configuration information and
3 1
1-2 passwords for booting.
After the POST runs, Setup runs automatically. The
3 1
2-3 maintenance menu is displayed.
The BIOS attempts to recover the BIOS configuration. A
3 1
None recovery diskette is required.
Product-Specific Features
OM13647
23