Dos Flash Utility - Acer Aspire E1-531 Service Manual

DOS Flash Utility

NOTE:
Plug the AC power adaptor to a power source before performing the DOS Flash Utility.
Perform the following to use the DOS Flash Utility:
Copy Flash.BAT to the USB HDD.
1.
Press F2 during boot to enter the BIOS Setup Utility.
2.
Select Boot menu to modify the boot priority order.
3.
Move the USB HDD to position 1 (refer to
4.
Information Main
Boot priority order:
1. HDD0 : Hitachi HTS545032B9A300
2. ATAPI CDROM : MATSHITADVD-RAM UJ870BJ
3. USB FDD :
4. Network Boot : BRCM MBA Slot 0200 v15.0.11
5. USB HDD :
6. USB CDROM :
F1 Help
Exit
Esc
Insert the USB HDD and reboot the computer.
5.
Enter the BIOS folder.
6.
At the command prompt, type BIOS.bat and press Enter to update BIOS.
7.
IMPORTANT:
Ensure the AC power adaptor is connected to the power source.
•
Do not disconnect the AC power adapter.
•
2-15
InsydeH20 Setup Utility
Security Boot
Select Item F5/F6
Select Menu
Enter
Figure 2:15. Changing the BIOS Boot Priority Order
C:\>BIOS.bat_
Figure 2:16. Executing BIOS.BAT
Boot on page 2-10).
Exit
Change Values
Select Sub-Menu
Item Specific Help
Use < > or < > to select a device, then
press <F5> to move it down the list, or
<F6> to move it up the list. Press <Esc>
to escape the menu
F9 Setup Defaults
F10 Save and Exit
System Utilities
Rev. 3.7