Sony KDL40W5500U Operating Instructions Manual page 50

Condition
The server cannot be found, a
list cannot be retrieved, and
playback fails.
Changes on the server are not
being applied or displayed
content differs from content
on the server.
Photo, music and/or video
files do not appear or icons are
not displayed.
The TV cannot be found from
renderer-compatible device
(the controller).
General
The TV's power cannot be
turned on.
The TV turns off
automatically (the TV enters
standby mode).
The TV turns on
automatically.
Some input sources cannot be
selected.
The remote does not function. • Replace the batteries.
50
GB
Explanation/Solution
• Once server settings are changed, turn the TV off and on by pressing 1
on the TV.
• Execute "Server Diagnostics" (page 29).
When using a PC as the server
• Check if the PC is turned on. Do not turn off the PC while accessing.
• If security software is installed on the PC, be sure to allow connections
from external devices. For details, refer to the manual supplied with your
security software.
• The load on the PC may be too high or the server application may
become unstable. Try the following:
–Stop the server application and restart it.
–Restart the PC.
–Reduce the number of applications running on the PC.
–Reduce the amount of content.
• Sometimes changes are not applied to displays on the TV even though
content has been added and/or deleted on the server. If this happens, go
back up one level and try opening the folder or server again.
Preliminary Check
• Check that the connected device supports DLNA.
• Operations are not guaranteed for all servers. Also, operations differ
depending on the features of the server and the content in question.
• Turn the connected device on.
Check Connections
• Check that the LAN cable and/or mains lead/AC power cord of the
server has not become disconnected.
Check Settings
• Check that the connected device is registered under "Server Display
Settings" (page 29).
• Check that the server is correctly configured.
• Check that the selected device is connected to the network and can be
accessed.
• If the "IP Address Settings" in "Network" under "Network Settings" is
set to "DHCP (DNS automatic)" or "DHCP (DNS manual)," it may take
some time to recognise devices if there is no DHCP server. Execute
"Server Diagnostics" (page 29).
Check Connections
• Check that the LAN cable and/or mains lead/AC power cord of the
server has not become disconnected.
Check Settings
• Check if the "Renderer Function" is activated (page 42).
• Check that the connected device is registered under "Renderer Access
Control" (page 42).
• Check if ENERGY SAVING SWITCH is on (page 10).
• Check if the "Sleep Timer" is activated, or confirm the "Duration"
setting of "On Timer" (page 31).
• Check if the "Idle TV Standby" is activated (page 32).
• Check if the "Presence Sensor" is activated (page 32).
• Check if the "On Timer" is activated (page 31).
• Select "Video Labels" and cancel the "Skip" setting for the input source
(page 37).