Installing Pcanywhere32 On The Netserver; Configuring Pcanywhere32 On The Netserver - HP D7171A - NetServer - LPr Administrator's Manual

Chapter 3
entry for server by right-clicking on the icon and going into
"Properties...".

Installing pcANYWHERE32 on the NetServer

If the HP NetServer you are setting up for remote access does not have
pcANYWHERE32 Server software already installed, you (or your customer or
client) must install pcANYWHERE32 at the NetServer. Otherwise skip the
following installation steps and proceed to the following section detailing the
configuration of pcANYWHERE32 on the NetServer.
Follow these instructions to install pcANYWHERE32 host software on the
NetServer:
1. Insert the HP NetServer Navigator CD-ROM into your HP NetServer's
CD-ROM drive and choose "Run" from the File menu in Program
Manager, or the Start menu in Windows, and enter:
x: \lxrpro8\utils\pca32\us\disk1\setup.exe
where x: is the drive letter of the HP NetServer's CD-ROM drive.
Follow the instructions on the screen to install pcANYWHERE32.
2. Once pcANYWHERE32 is installed, restart the server and run
pcANYWHERE32 by double-clicking the pcANYWHERE32 program
icon in the pcANYWHERE32 program group.

Configuring pcANYWHERE32 on the NetServer

The first time you start pcANYWHERE32, the Smart Setup Wizard helps you
configure your system and prompts you for basic information including COM
port and modem type. Select the modem on the list that most closely matches the
one you intend to use.
In Windows NT, to set up Serial A (COM 1) as the serial port:
1. Click Ports in the Control Panel.
2. In the Ports dialog box, select COM 1.
3. Click "Settings..." and then "Advanced...".
Configure using the following address and IRQ settings:
20
Installing Graphic Console Redirection