Preparing For The Processor Upgrade - HP D7171A - NetServer - LPr Installation Manual

Chapter 1
To install this accessory you need the following tools, plus the key for the front
lock, if the HP NetServer is locked:
A portable field service grounding kit (3M part number 8505 or
equivalent) containing a wrist strap, anti-static mat, and cable. Use this kit
to prevent damage to the system from static electricity.
A 1/4-inch flat-blade screwdriver.

Preparing for the Processor Upgrade

WARNING Before removing the cover, disconnect the power cord and
unplug telephone cables. Disconnect power cords to avoid
exposure to high energy levels that may cause burns when
parts are short-circuited by metal objects such as tools or
jewelry. Disconnecting the power cord also disables the
standby voltage; simply turning off the NetServer does not.
Disconnect telephone cables to avoid exposure to shock
hazard from telephone ringing voltages.
CAUTION Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components.
You must access the NetServer system board to install this accessory kit. Separate
procedures follow for removing the HP NetServer LH 3 bezel and covers and
removing the HP NetServer LH 3r system board.
Processor Module Installation
3