Converting SCSI Configuration from Simplex to Duplex
Removing the Covers
Removing the Covers
CAUTION
Do not operate your HP Server without the front and top covers in place. Operation of the HP
Server without the front and top covers in place will result in EMI suseptibility, overheating
problems and/or system failure.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Removing the Front Cover
To remove the front cover, perform the following steps:
Step 1. Loosen the four captive thumbscrews that hold the front cover in place.
Step 2. Raise the cover slightly, and pull the cover toward the front of the server to free the tabs from the
slots in the center of the chassis.
Figure 2-2
Removing the Front Cover
12
Thumbscrews
Chapter 2