Removing A Hot Plug Board - HP D7171A - NetServer - LPr User Manual

Appendix B
Off
9. If the Slot Status for the desired PCI slot changes to Powered Off, go to
next section, "Removing a Hot Plug Board", to physically remove the PCI
board from the PCI slot (slot P5).

Removing a Hot Plug Board

Use this topic to physically remove a PCI Hot Plug Board from its PCI slot.
1. At the front of the HP NetServer, remove the front bezel from the
NetServer (refer to your Installation Guide).
2. Extend the HP NetServer chassis safely from the rack (refer to your
Installation Guide).
3. Remove the PCI Access Panel (refer to your Installation Guide).
CAUTION Do Not Drop Screws or Other Metal Objects into the HP
NetServer.
4. Verify power to the desired PCI slot is turned off, by checking the power
LED associated with the desired PCI slot. See Figure 24 and Table 7.
The green Power LED must be OFF, before attempting to open the PCI
hold-down latch.
32
Warranty, Software License and Support
board from this slot.