Replacing A Hot Plug Board - HP D7171A - NetServer - LPr User Manual

Appendix B
CAUTION When handling electronic components, wear a wrist strap and
use a static-dissipating work surface connected to the chassis
when handling components. Ensure the metal of the wrist
strap contacts your skin.
10. Grasp the edge of the PCI board firmly and pull upward. See Figure 27.
Try to pull the board straight up without wiggling it side to side along the
length of the board.
Ensure
PCI hold-down
latch is at least half open
before removing board.
11. Place the PCI board on a static free surface.
12. Go to the next section "Replacing a PCI Hot Plug Board" to install a new,
but identical PCI Hot Plug board in the PCI slot.

Replacing a Hot Plug Board

Use this topic to replace a PCI Hot Plug Board. The following conditions must be
met before replacing a PCI Hot Plug Board:
36
Warranty, Software License and Support
Remove board
Figure 27. Removing PCI Boards