Netware 4.20 Environment; Installing The Drivers During A Fresh Install Of Netware 4.20 - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide

NetWare 4.20 Environment

This section explains how to install the driver, netr4m.ham, for
Novell NetWare 4.20. If you are performing a first time NetWare
installation, see Installing the Drivers During a Fresh Install of NetWare
4.20 on page 4-10. If NetWare is already installed in your system, see
Installing the Driver When NetWare 4.20 is Already Installed on
page 4-12. You need to load the netr4m.ham driver for every
HP NetRAID-4M controller installed in your system.
Note:
We recommend that you install your NetWare
operating system on a container to take advantage of the
redundancy and performance features of the container.

Installing the Drivers During a Fresh Install of NetWare 4.20

Follow these instructions only if you are installing NetWare 4.20 for
the first time. If you want NetWare to reside on a container, first
create a boot container (see Appendix B, Using the BIOS Container
Configuration Utility), then install the drivers and software on that
container.
Note:
If you are using either NetWare Automatic Partition
Creation or Navigator Installation Assistant you may
encounter the following error message during the driver
installation: No information about device 1 could be
obtained. Program execution may not continue normally.
Press Escape to Continue. If this happens, press Escape and
the installation will continue normally.
1
Begin installation of NetWare 4.20 on your server as instructed
in your NetWare documentation.
2
When the Driver Actions screen appears, select Select
additional or modify selected disk/LAN drivers and press
Enter.
3
Highlight Disk and CD-ROM Drivers and press Enter.
4
On the Additional Driver Actions screen, highlight Select an
additional driver and press Enter.
4-10