Ac Panel And Power Cord Retainers - HP StorageWorks 2/64 - Core Switch Installation Manual

NOTE: The ON/OFF switches for CP cards are identical to the ON/OFF switches on the
16-port cards (see
2. Verify that the AC switch covers are installed over the AC switches.
These clear plastic covers fit over the AC switches with their edges tucked underneath the
outlet covers, preventing the AC switches from being powered on or off accidentally (see
Figure 12).
3. Connect the AC power cord retainers to the chassis:
a. Orient a retainer against the AC panel as shown in
b. Place the retainer tabs under the two jack screws on either side of the power receptacle
and tighten the screws.
4. Repeat step 3
same direction as the power receptacles).
AC Switch
(2x)
Figure 12

AC panel and power cord retainers

44 Installing and configuring the switch
Figure 11).
for the other retainer (note that the power cord retainers are oriented in the
Jack
Screw (2x)
AC Power
Receptacle (2x)
3
1 &
L Y
P P
S U
E R
W
P O
H z
- 6 0
5 0
A
1 2
C
V A
4 0
0 - 2
2 0
Clamping
Screw
Figure
Clamping
Screw
4
2 &
L Y
P P
S U
E R
W
P O
H z
- 6 0
5 0
A
1 2
C
V A
4 0
0 - 2
2 0
!
scale: 5/16" = 1"
12.
S
E R
W
P O
AC Switch Cover (2x)
Power Cord
Retainer (2x)
Retainer
Attaching
Screw (2x)