HP StorageWorks 16-EL - SAN Switch Reference Manual page 18

Introduction to System Error Messages
Table 3: Commands to View or Configure System Logs (Continued)
errdump
errshow
memshow
poterrshow
portflagsshow
portlogclear
portlogdisable
portlogdump
portlogdumpport
portloginshow
portlogpdisc
portlogreset
portlogresize
portlogshow
portlogshowport
setdbg
seterrlvl
setverbose
supportshow
syslogdipadd
syslogdipremove
syslogdipshow
18
Command
Display the entire error log with no page breaks.
Display the entire error log with page breaks.
Display the current memory usage of the switch.
Display the port error summary.
Display the port status bitmaps for all ports in a switch.
Clear the Port Log. If the Port Log is disabled, this
command enables it.
Disable the Port Log facility.
Display the Port Log without page breaks.
Display the Port Log of specified port without page breaks.
Display port logins.
Set or clear the debug pdisc_flag.
Enable the Port Log facility.
Resize the Port Log to the specified number of entries.
Display the Port Log with page breaks.
Display the Port Log of the specified port with page
breaks.
Set the level of debug messages reported by a particular
module.
Set the level of errors reported by a particular module.
Set the verbose level of a particular module within the
Fabric OS.
Execute a list of diagnostic and error display commands.
The output is used by technical support to diagnose and
correct problems with the switch. The output from this
command can be very long.
Add an IP address as a recipient of event or error
messages.
Remove an IP address as a recipient of event or error
messages.
View the currently configured IP addresses that are
recipients of event or error messages.
Diagnostic and System Error Messages Version 3.1.x Reference Guide
Description