HP StorageWorks SN6000 Command Line Interface Manual page 181

switch
Resets the switch without a power-on self test (POST). This is the default. This reset disrupts traffic
and does the following:
• Activates the pending firmware
• Closes all management sessions
• Clears the event log. To save the event log before resetting, see the
To reset the switch with a power-on self test, see the "hardreset" (page 154). To reset the switch
without disrupting traffic, see the "hotreset" (page 157).
NOTE: The following files are deleted from the switch during a switch reset:
• Firmware image files that have not been unpacked
• Configuration backup files
• Support files
system
Resets the following system configuration settings to the factory default values:
• DNS host (Table 24)
• IPv4 Ethernet (Table
• IPv6 Ethernet (Table
• Event logging (Table
• NTP (Table 28)
• Timers (Table 29)
NOTE: Because this operand changes network parameters, the workstation could lose
communication with the switch. This operand does not affect installed license keys.
zoning
Clears the zoning database and deactivates the active zone set. The zoning configuration
parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain unchanged. See
Table 20 for information about the zoning configuration parameters.
HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 181
25)
26)
27)
"set log" (page 206).