Ide Connector - Asus P5Q SE R User Manual

2. IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select," ensure that all other device
jumpers have the same setting.

IDE Connector

P5Q SE/R
ASUS P5Q SE/R
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode of Cable connector
device(s)
- Black
Black
Master
Slave Gray
Master Black or gray
Slave
Orient the red markings
on the IDE ribbon cable to
PIN1.
2-25