Ide Connector (40-1 Pin Pri_Ide) - Asus M4a785t-M - 785G Am3 Max-16Gb Ddr3 Uatx Pcie16 1Pcie 2Pci2.2 User Manual

2.

IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for Ultra DMA 133/100/66 signal cable. There are three
connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect
the blue connector to the motherboard's IDE connector, then select one of the following
modes to configure your devices:
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the
same setting.
ASUS M4A785T-M
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode of device(s) Cable connector
-
Master
Slave
Master
Slave
Black
Black
Gray
Black or gray
1-23