2.4.2
Memory configurations
You may install 512 MB, 1 GB, 2 GB and 4GB unbuffered non-ECC DDR2 DIMMs
into the DIMM sockets.
•
You may install varying memory sizes in Channel A and Channel B. The
system maps the total size of the lower-sized channel for the dual-channel
configuration. Any excess memory from the higher-sized channel is then
mapped for single-channel operation.
•
It recommended that to install the memory module from yellow slots for
better overclocking capability.
•
Always install DIMMs with the same CAS latency. For optimum compatibility,
it is recommended that you obtain memory modules from the same vendor.
•
When installing total memory of 4GB capacity or more, Windows 32-bit
operation system may only recognize less than 3GB. Hence, a total installed
memory of less than 3GB is recommended.
•
This motherboard does not support memory modules made up of 256 Mb
chips.
•
Due to chipset limitation, this motherboard can only support up to 16 GB
on the operating systems listed below. You may install a maximum of 4 GB
DIMMs on each slot.
•
The default memory operation frequency is dependent on its SPD. Under
the default state, some memory modules for overclocking may operate at a
lower frequency than the vendor-marked value. To operate at the vendor-
marked or at a higher frequency, see section 3.4 Ai Tweaker menu for
manual memory frequency adjustment.
•
The memory modules may require a better cooling system to work stably
under full loading (4 DIMMs) or overclocking setting.
ASUS P5Q PRO
64-bit
Windows
®
XP Professional x64 Edition
Vista x64 Edition
®
Windows
2-11