Asus P5P43T User Manual page 35

User manual
Table of Contents

Advertisement

6.
IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are
three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the
same setting.
ASUS P5P43T
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode of device(s)
Cable connector
-
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
1-25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents