Internal Connectors - Asus P5KEPU - Motherboard - ATX User Manual

2.7.2

Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
P5K/EPU Floppy disk drive connector
2. IDE connector (40-1 pin PRI_E IDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device.
P5K/EPU IDE connector
Single device
Two devices
2-26
®
®
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
FLOPPY
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PRI_EIDE
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Mode of
device(s)
-
Master
Slave
Master
Slave
Chapter 2: Hardware information
Cable connector
Black
Black
Gray
Black or gray