Change Time Display - American Audio UCD-100 Operating Instructions Manual

BaSiC OPEraTiON
11. SETTING OUTPUT vOLUME LEvEL
this function lets you set the output volume level.
Press the traCk kNOb (14) and press either the
(-) PitCh bEND buttON or the (+) PitCh but-
tON (11) depending on if you want to raise or lower
the volume.
figure 13
12. CHANGING THE TIME DISPLAY (26)/TIME BAR (27):
the time may be displayed in three different modes; total Remain, Remain, and Elapsed. During normal play-
back, pressing the tiME buttON (5) as in figure 14, will change the time display information (26) in the LCD.
the following is a break down of the time settings and their definitions:
1) tOtAL REMAIn (34) - this details the time in the LCD as the current CDs' total remaining
time.
2) REMAIn (34) - this details the time in the LCD as the current tracks' remaining running time.
3) ELAPSED - this details the time in the LCD as the current tracks' elapsed running time.
The unit will indicate the ELaPSED time when neither the TOTaL rEMaiN Or rEMaiN indica-
tors are showing. Note: When playing a Mp3 disc the TOTaL rEMaiN time of a disc cannot be
shown. Only the rEMaiN time and ELaPSED time of the track.
26
tIME BAR InDICAtOR - the time bar in the LCD visually details the time defined in the tiME MEtEr ( ). this
this bar will begin
bar is also dependent on the selected time function; rEMaiN (34) or tOtaL rEMaiN (34).
to flash when 15 seconds of a track remain and will begin to rapidly flash when three seconds of a
track remain. the flashing bar is a great visual reminder a track is about to end. the flashing bar will
function regardless of which time mode the unit is in.
figure 14
American Audio - www.americanaudio.com - UCD-100 Instruction Manual Page 18
© ®