Gigabyte GA-Z77X-UD5H User Manual page 88

Step 3:
After entering the CREATE VOLUME MENU screen, enter a volume name with 1~16 letters (letters cannot be
special characters) under the Name item and press <Enter>. Then, select a RAID level (Figure 4). RAID levels
supported include RAID 0, RAID 1, RAID 10, and RAID 5 (the selections available depend on the number of
the hard drives being installed). Press <Enter> to proceed.
Intel(R) Rapid Storage Technology - Option ROM - 11.0.0.1339
Copyright(C) 2003-11 Intel Corporation. All Rights Reserved.
Name :
RAID Level :
Disks :
Strip Size :
Capacity :
Sync :
[hi]-Change
Step 4:
Under Disks item, select the hard drives to be included in the RAID array. If only two hard drives are installed,
they will be automatically assigned to the array. Set the stripe block size (Figure 5) if necessary. The stripe block
size can be set from 4 KB to 128 KB. Once you have selected the stripe block size, press <Enter>.
Intel(R) Rapid Storage Technology - Option ROM - 11.0.0.1339
Copyright(C) 2003-11 Intel Corporation. All Rights Reserved.
Name :
RAID Level :
Disks :
Strip Size :
Capacity :
Sync :
[hi]-Change
Appendix
[ CREATE VOLUME MENU ]
Volume0
RAID0(Stripe)
Select Disks
128KB
111.7 GB
N/A
Create Volume
[ HELP ]
RAID0: Stripes data (performance).
[TAB]-Next [ESC]-Previous Menu
Figure 4
[ CREATE VOLUME MENU ]
Volume0
RAID0(Stripe)
Select Disks
128KB
111.7 GB
N/A
Create Volume
[ HELP ]
The following are typical values:
RAID0 - 128KB
RAID10 - 64KB
RAID5 - 64KB
[TAB]-Next [ESC]-Previous Menu
Figure 5
- 88 -
[ENTER]-Select
[ENTER]-Select