Control Commands Via Lan; Use Of Telnet - Panasonic PT-CX200U Operating Instructions Manual

Control commands via LAN

Use of telnet

You can control the projector by using the telnet application*
Normally, the telnet application is available on your computer.
* The telnet 10000 port is used to control the projector.
Control

(For example, in case of using the telnet application of Windows XP Professional.)
1) Select Run... submenu from Start menu on the computer. Type "telnet" onto the Open text area on the dis-
played window and press OK button.
2) The telnet application will start and the following window will be displayed. Type as below to connect the pro-
jector.
> open 192.168.1.201 10000 [return]
* Use the IP address assigned to the projector.
3) When communication is established correctly, the word "PASSWORD:" appears on the window. Type the login
password (Network PIN code*
up the Network PIN code, just press "Enter" key.
When the word "Hello" is replied, login has been succeeded.
* The password "1234" is used for the example.
*
1 Further instructions about the telnet application, please see the on-line guide on your computer.
*
2 The password is a Network PIN code decided item "Network PIN code setting". If the authentication of the entered password is failed 4
times continuously, the communication will be disconnected automatically. Please try again for the connection.
22
) for the projector and then press "Enter" key on the keyboard. If you do not set
2
installed on your computer.
1