Table of Contents
Advertisement
TV Stand Installation
TV LED19A30RQ is packaged with the base of the TV stand separated from the cabinet. To setup the base of the TV table stand,
please carry out the installation according to the instructions below.
Step One
Place the TV faced down on a soft cloth or cushion to prevent the LED LCD panel from being damaged.
Note:
1. The LED LCD panel can be scratched easily, so please choose an absolutely flat surface to place the TV, and use soft cloth or
cushion to protect the TV panel. Do not put TV on table directly.
2. Always unplug the AC cord first when installing or removing the stand.
Step Two
Take the base of the stand. You should take notice of the direction about the base
installation, please refer to the picture given right side:
Step Three
Please align four holes of the base and four screwholes of the neck (align the location labels on the back of the base and the
neck), then insert the base to the neck.
Step Four
Then insert four tapping screws (all same in size) and tighten them.
Please refer to the picture given below:
Washer Plate*
* Washer plate should be shown on bottom side of the stand base
The bottom view of the TV (Front cabinet faces down)
Note:
1. Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
2. Make sure to distinguish between the front and back of the Stand base.
3. Make sure that at least two persons lift and move the TV.
Do not insert your fingers into the stand base slot of the TV when installing the stand base.
!
Under Surface
Pedestal Screws Quantity
M3 x 10mm
4pcs
TV Back cabinet
TV Front cabinet
Part #
RS01PB310H
9
Hide quick links:
Advertisement
Table of Contents
