HP D5970A - NetServer - LCII Installation And Configuration Manual page 99

[xxxxx041] Command aborted
[xxxxx042] Command aborted
[xxxxx043] Command aborted
[xxxxx044] Command aborted
[xxxxx045] Command aborted
An internal condition caused the driver to abort the command. In most cases,
the command is retried and is recovered, and normal operation continues.
[xxxxx046] Target device did not respond to abort sequence
The target device did not abort the command requested by the driver. Some
devices do not support the abort command properly. Normally, this indicates a
faulty or noncompliant target device.
[xxxxx047] Command aborted
An internal condition caused the driver to abort the command. In most cases,
the command is retried and is recovered, and normal operation continues.
[xxxxx048] Unable to abort command
An error occurred while aborting a command. Possibly, the command has
already completed and there is nothing to abort.
[xxxxx049] Command abort in progress
This indicates an abort command has been issued. This is a normal operating
condition.
[xxxxx051] Target device did not respond to reset sequence
The target device did not reset correctly as requested by the driver. Normally,
this indicates a faulty or noncompliant target device.
[xxxxx081] Adapter initialization failure
An error has occurred while the driver was setting up its internal data structures.
Verify that your adapter is supported by this version of the driver.
[xxxxx083] Adapter not supported by this version of the driver
Your adapter is not supported by the driver on your system. You may have
installed a new adapter and have not updated the driver on your system.
93