HP D5970A - NetServer - LCII Installation And Configuration Manual page 100

[xxxxx096] Adapter hardware initialization failure - possible resource conflict
The driver has attempted to initialize the adapter hardware but failed. This
might suggest that the adapter resources (e.g., IRQ) conflict with another board
installed in your system.
[xxxxx097] Unable to allocate memory
This indicates that there may be a problem with the amount of memory installed
in your system. Verify that your system has at least the minimum amount of
memory required by your operating system.
[xxxxx098] Exceeded maximum number of host bus adapters
The driver has detected more host bus adapters than is supported by this version
of the driver or operating system.
[xxxxx0a4] SCSI bus reset by third party
Hardware such as an array enclosure may have reset the SCSI bus. This is a
normal condition unless you receive additional errors.
[xxxxx0a5] SCSI bus reset by host adapter
The host adapter may have reset the SCSI bus. This is a normal condition unless
you receive additional errors.
[xxxxx0cf] System configuration error
The driver encountered an error with your hardware. Refer to your host
adapter's user's guide for troubleshooting information.
[xxxxx0d0] Command timeout
The target device is either busy, not ready, malfunctioning, or is not present.
Refer to your host adapter's user's guide for troubleshooting information.
[xxxxx0d7] Target device scan failed
The driver encountered an error scanning the target device. Refer to your host
adapter's user's guide for troubleshooting information.
94