2.
IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There
are three connectors on each Ultra DMA 133/100 signal cable: blue, black,
and gray. Connect the blue connector to the motherboard's IDE connector,
then select one of the following modes to configure your device.
®
P5E64 WS EVOLUTION
P5E64 WS Evolution IDE connector
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
ASUS P5E64 WS Evolution
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
Mode of
device(s)
-
Master
Slave
Master
Slave
Cable connector
Black
Black
Gray
Black or gray
2-27