Windows Xp - HP Xw4550 - Workstation - 2 GB RAM Installation Manual

NOTE:
optical drives in the same workstation," earlier in this document, for recommended SATA
configuration information.
7. Reassemble the workstation by reinstalling the front bezel and access panel, and then
reconnecting any peripheral devices to the workstation.
Enabling digital audio
This section provides the information required to enable digital audio for the drive, based on the
operating system in use.

Windows XP

When using Windows XP on your workstation, enable the disk drive digital audio capability as follows:
1. From the Control Panel double-click System.
2. Click the Hardware tab, then click Device Manager.
3. Double-click DVD/CD-ROM drives.
4. Right-click the appropriate optical drive, then click Properties.
5. Click the Properties tab, then click the Enable Digital CD Audio for this CD-ROM Device
checkbox.
6. Click OK.
Windows Vista Business
The ODD digital audio capability is enabled by default when using the Windows Vista Business operating
system.
Red Hat Enterprise Linux (RHEL)
When running Red Hat Enterprise Linux, use the utility XMMS to enable and configure the digital audio
capability for the SATA Optical Drive.
RHEL 3
When running RHEL3, go to the XMMS website at www.xmms.org and download the XMMS interface.
Follow the directions provided in order to enable digital audio for the SATA Optical Drive.
RHEL 4
When running RHEL 4, enable the audio as follows:
1. Enter the following command line to launch the XMMS interface:
# xmms
2. In the Audio Player window, click on the arrow in the upper-left corner.
3. In the resulting drop-down window, click Options, then Preferences.
4. In the Preferences window, click the Audio I/O Plugins tab, then select CD Audio Player.
ENWW
Refer to "Configuration rules and assumptions when installing both SATA and PATA
Enabling digital audio 9