HP Xw4550 - Workstation - 2 GB RAM Installation Manual page 11

NOTE:
2. Slowly pull the tray out from the drive until the tray is fully extended.
3. Remove the disc.
4. Push the tray back into the drive until the tray locks in place.
SATA interface information
Serial ATA Standard
The Serial ATA interface is fully compliant with ATA protocol, and will appear to the operating system
as a standard ATA device. The SATA interface cable can be installed with the 90-degree connector
attached to either the drive or the system board, whichever may be required by your workstation
hardware configuration.
NOTE: The SATA interface cables in your kit may not be identical to the cable in the following
illustration. Each SATA interface cable connects only a single device to a controller.
ENWW
The drive bezel and drive controls may not be identical to those shown.
SATA interface information 11