HP Vectra 486M - MI Setup Manual page 15

3.2.3. PXE Server: Boot Server Configuration
From the main interface, right click on Boot Server (green
icon) and then click "Configure Boot Server".
In the "General Options" tab, uncheck "Use DHCP Port for
Listening" (used when the PXE server is not a DHCP server).
Uncheck all other boxes. Ensure the multicast IP addresses are NOT
within your network subnet's IP address range (check the DHCP
server scope). Validate this by clicking "OK"
In the "Scope" tab, check "Serve all Clients" (or add your own
filters) and validate this by clicking "OK"
15