Windows 2000 Driver - HP Tc2110 - Server - 128 MB RAM Update Manual

Installing HP NetRAID-1M drivers on the HP Server tc2110

Windows 2000 Driver

NOTE: These driver installation instructions assume the following:
·
Logical drives have already been created on the HP NetRAID-1M controller (the NetRAID Express Tools
configuration utility is accessed during system boot up by pressing <CTRL> <M>).
·
You have already created the HP NetRAID-1M Windows 2000 driver diskette from the HP Server tc2110 Startup
CD
Option 1: Installing the HP NetRAID-1M driver while installing the operating system
1. Place the Windows 2000 CD in the CD-ROM drive. Power off and on to reboot the system. You will see a message
that reads "Setup is inspecting your hardware configuration." Then the setup screen will be displayed.
2. Press <F6>.
3. In next screen which shows "Setup could not determine the type ...", Press <S> to select additional hardware.
4. When prompted to insert driver diskette, please insert NetRAID-1M driver's diskette created with the HP Startup
CD. Press <Enter> to continue.
5. Select "Hewlett-Packard NetServer NetRAID-1M/2M RAID Controller" from the list provided on the display.
6. If you have no other drivers that you need to install, press <Enter> to continue with the installation. Otherwise, repeat
steps from 1. to add more devices.
7. Press <Enter> to continue at the "Windows 2000 Server Setup. Setup Notification..." screen and follow the
instructions provided on the screen.
Option 2: Installing the HP NetRAID-1M driver after the operating system has been installed (the HP
NetRAID-1M is not the boot controller)
1. Ensure that the HP NetRAID-1M controller is installed in your system, then reboot your system so that the system
can recognize the controller. When the system is rebooted and the controller recognized, Windows 2000
automatically launches the Found New Hardware wizard, which you use to install the Windows 2000 drivers for the
HP NetRAID-1M controller.
2. The Found New Hardware wizard displays a Files Needed dialog box, which prompts for the location on the A: drive
for the driver files for the HP NetRAID-1M controller. Insert the drivers diskette created with the HP Startup CD-
ROM. When the driver finishes installing, click Finish to exit the Found New Hardware wizard.
3. At the message "Do you want to restart the computer now?", remove the diskette from the floppy drive and click Yes
to reboot the system.
Windows NT Driver
Option 1: Installing the HP NetRAID-1M driver while installing the operating system
NOTE: These driver installation instructions assume the following:
·
Logical drives have already been created on the HP NetRAID-1M controller (the NetRAID Express Tools
configuration utility is accessed during system boot up by pressing <CTRL> <M>).
·
You have already created the HP NetRAID-1M Windows NT driver diskette from the HP Server tc2110 Startup CD
1. Reboot the system with the Windows NT CD-ROM in the drive.
2. Press the <F6> key as soon as the blue screen shows up after the system is booting from the CD-ROM. This will skip
the controller's auto-detection. Please note that you may have to press the <F6> key multiple times while booting
from the CD-ROM.
3