Shared Storage Software Setup; Install The Fibre Channel Driver On Windows Nt - HP D5970A - NetServer - LCII Configuration Manual

6 – Shared Storage Software Setup

Install the Fibre Channel Driver on Windows NT

The Hewlett-Packard Model 30/FC Disk Array and the cabinet should be powered down at this time.
To install the Fibre Channel driver Windows NT, perform the following steps on each HP NetServer in the cluster:
a. Power up the HP NetServer if it is not already powered up.
b. Start Windows NT if it is not running and log into an account with administrative privileges.
c. Insert the Hewlett-Packard driver diskette into the floppy drive.
d. From the bar, select
Start
e. From the Settings
f. From the Control Panel
g. From the
SCSI Adapters
h. From the
Drivers
i. Click
Have Disk
j. From the floppy disk drive, click
k. Click .
OK
When the installation is complete, remove the diskette, shut down Windows NT, and, without powering up the disk
array, reboot the HP NetServer to load the driver.
Power down the HP NetServer.
.
Settings
menu, click Control Panel
window, double-click
window, click the
window, click .
Add
.
HP HHBA-5000X Fibre Channel Host Controller
.
SCSI Adapters .
.
Drivers tab
35
.