HP Tc2110 - Server - 128 MB RAM Update Manual page 6

9. Press <Enter> to automatically scan the diskette or press <F3> to specify a different path.
10. In the Select a driver to install screen, highlight the mega4_xx.ham entry.
11. Press <Enter> to select the highlighted driver.
12. Select yes to copy the mega4_xx.ham driver.
13. In the Specify a server boot path (where SERVER.EXE will be) screen, either press <Enter> to accept the default or
customize the path.
14. If the mega4_xx.ham driver has been previously installed on your server, you will see the Save existing file...
prompt. Select No to overwrite the mega4_xx.ham and mega4_xx.ddi files.
15. In the MEGA4_XX Parameters screen, you will be prompted for the controller's Slot Number. If you know the value,
enter it now. Otherwise, follow these steps to determine the slot number:
a. Return to the System Console (press <CTRL> <ESC> and select the System Console option.)
b. Type load <path>\mega4_xx
(where <path> is the path to the mega4_xx.ham driver on the floppy,
example: load a:\mega4_xx.ham)
c. Write down the HIN number that is displayed.
Example:
MegaRAID Supported SLOT Choices:
0. No Selection
1. PCI.SLOT_8.1 (HIN 802)
The HIN number is 802 in the example above.
d. Enter 0 to select No Selection.
e. Return to the nwconfig screen (press <CTRL> <ESC> and select the NWConfig option.)
f. In the Slot Number field, type in the HIN number that you wrote down in step c.
16. Press <F10> to Save parameters and settings.
17. Select Save parameters and load driver.
18. When prompted with Do you want to select an additional Disk driver?, select No.
19. Press <ESC> multiple times until the Exit nwconfig? prompt is displayed.
20. Select Yes and press <Enter> to exit nwconfig.
The HP NetRAID-1M driver is now installed. Configure the partitions/volumes via the standard Novell process.
Installing HP NetRAID-1M Utilities on the HP Server tc2110
- NOTE: These installation instructions assume that you have already installed the operating system and the HP NetRAID-
1M driver. For complete information about these utilities, see the HP NetRAID Series User Guide in Information Assistant
on the HP Netserver Documentation CD-ROM that was included with the HP NetRAID-1M accessory.
Microsoft Windows NT 4.0 and Windows 2000
Follow the instructions outlined in this section to install the following HP NetRAID-1M software:
·
HP NetRAID Assistant (nraid.exe)
·
HP NetRAID Monitor Service (megaserv.exe)
·
HP NetRAID Consistency Check Scheduler (megactrl.exe)
6